[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [TCML] MOT cleanup
Paul,
It is not necessary to completely remove the filament windings. Just
trim them back to a convenient length, and keep the ends apart.
Dave
On 3/28/2012 9:24 PM, mrapol@xxxxxxxxxxxx wrote:
I am preparing a MOT for use, and I was wondering if it is better to
remove the heater wire winding, or just snip it off so that it's out
of the way? Is there any drawback to just cutting it back, assuming I
seal the ends?
Paul
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla