Re: [TCML] welder for a ballast........

["Quarkster" <quarkster@xxxxxxx>]

Jon -

David's initial post (10-18) stated:

"....has anyone fried a welder when used as a pole trans Jacobs Ladder./T 
coil balast ?"

The type of device being ballasted was NOT clearly specified, hence the 
confusion.

Regards,
Herr Zapp

----- Original Message ----- 
From: "Jon Danniken" <danniken@xxxxxxxxxxx>
To: "Tesla Coil Mailing List" <tesla@xxxxxxxxxx>
Sent: Tuesday, October 20, 2009 4:02 PM
Subject: Re: [TCML] welder for a ballast........


> Quarkster wrote:
> > David -
> >
> > Well, that explains it.
> >
> > Since this is a Tesla Coil discussion group, it would help avoid
> > confusion if you would clearly state what kind of device you are
> > working with.
>
> He stated in his initial post starting the thread that this was for a 
> Jacobs Ladder.  Personally, I found no confusion as to what he was doing 
> with the ballast.
>
> Jon
> _______________________________________________
> Tesla mailing list
> Tesla@xxxxxxxxxx
> http://www.pupman.com/mailman/listinfo/tesla 

_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla