RE: [TCML] welder for a ballast........

["Jim Mora" <wavetuner@xxxxxxxxx>]

Hi David,

That's rock and roll time! I had the same welder and sold it a few months
ago as I fell on a satuable reactor for my control cabinet and a BIG Miller
welder from a School District.

I ran the JL at full power 5-10 minutes on the 225 with big 60hz vibrations
each time the arc started. I opened the Miller and all was well! ...lots of
head room. Don't use a Variac on the welder unless you give full power to
the fan.

Happy Halloween and Frankenstein sparks!

Jim Mora

-----Original Message-----
From: tesla-bounces@xxxxxxxxxx [mailto:tesla-bounces@xxxxxxxxxx] On Behalf
Of david baehr
Sent: Tuesday, October 20, 2009 5:21 AM
To: tesla@xxxxxxxxxx
Subject: RE: [TCML] welder for a ballast........


yes, 12" +  ,...this is a Jacobs Ladder..

 

 


 
> From: quarkster@xxxxxxx
> To: tesla@xxxxxxxxxx
> Subject: Re: [TCML] welder for a ballast........
> Date: Mon, 19 Oct 2009 21:19:56 -0700
> 
> David -
> 
> 12" plus arcs wouldn't seem to be very impressive output for a system 
> pulling 60-70 Amps input power .......
> 
> Did you mean 12' arcs?
> 
> Regards,
> Herr Zapp
> 
>  		 	   		  
_________________________________________________________________
Hotmail: Trusted email with Microsoft's powerful SPAM protection.
http://clk.atdmt.com/GBL/go/177141664/direct/01/____________________________
___________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla

_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla