[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [TCML] Frequencies
Paul Brodie wrote:
A standard commercial automobile engine runs at 6,000 rpm tops. The
ignition coils are deigned to be driven at this frequency. This works
out to 100Hz or less, 6000 divided by 60 seconds.
Only if you have a 2 cylinder engine(!).. a six will fire 3 times per
revolution (300Hz) an eight more.. Got that V12 Jag and you will be
firing at 600 Hz.
From much
experimentation, I have found that the coils I have worked with,
primarily the Accel Super Coil, will continue to produce higher voltage
up to around 1kHz and then start to drop off. If you try to overdrive
the ignirion coil, you will get less output, not more. Also, wouldn't it
be better if you let everyone know what it is you are trying to
accomplish with this? I believe you said you want to try to charge caps
to first 25kV and then to 50kV in stages and use these to drive some
sort of flash. Is this correct?
This is the kind of circuit that is hard to do empirically. You can
copy a known good circuit from someone else (e.g. the multitude of triac
dimmer, capacitor, ignition coil circuits) and it will work ok. But if
you start to modify, or try to do other things, you need to understand
the theory to know where you're going.
ignition coils are not a great way to make a generic HV source. They're
great if you want sparks or HV pulses (where the pulses are of a certain
shape and duration). But as soon as you move away from what they do
best (e.g. firing a spark plug), you'll find you're adding circuit on
circuit to get where you need to go.
What, exactly, do you need, HV pulse wise?
Voltage, rep rate, load current, pulse width?
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla