RE: [TCML] How to use an arc welder as a ballast?

["Lau, Gary" <Gary.Lau@xxxxxx>]

I have never attempted to use a pig nor looked into how to ballast one, so take my comment with a grain of salt.  But I thought I recall that the LV welding electrodes need to be shorted together?  Could be important...

Regards, Gary Lau
MA, USA

> -----Original Message-----
> From: tesla-bounces@xxxxxxxxxx [mailto:tesla-bounces@xxxxxxxxxx] On
> Behalf Of David Rieben
> Sent: Saturday, May 03, 2008 11:47 PM
> To: Tesla Coil Mailing List
> Subject: Re: [TCML] How to use an arc welder as a ballast?
>
> Hi Marcus?
>
> Simply wire the 240 volt input of your welder in series with the 240
> volt input bushings on the side of the pig. Then turn the current selector
> of your welder to the desired level (most will turn it to the 225 amp
> selection, or wide open) and this should allow about 50 amps or so
> of current flow into the pig when its high voltage output bushings are
> shorted with a Jacob's ladder.
>
> David Rieben
>
> ----- Original Message -----
> From: "marcus masencup" <mmasencup@xxxxxxxxx>
> To: <tesla@xxxxxxxxxx>
> Sent: Saturday, May 03, 2008 4:55 PM
> Subject: [TCML] How to use an arc welder as a ballast?
>
>
> >I am stepping up to pole pigs after years of using NST's. I have read
> > everything I can find online and for me it seems that an arc welder is the
> > easiest way to add the current limiting and ballast I need to run the
> > 10kva
> > pole pig I have. What I can't find is how I need to wire the arc welder up
> > with the pole pig? Any help on how to wire this would be great, thanks!

_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla