[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: Winding technique
- To: tesla@xxxxxxxxxx
- Subject: Re: Winding technique
- From: "Tesla list" <tesla@xxxxxxxxxx>
- Date: Mon, 03 Jan 2005 17:18:08 -0700
- Delivered-to: testla@pupman.com
- Delivered-to: tesla@pupman.com
- Old-return-path: <teslalist@twfpowerelectronics.com>
- Resent-date: Mon, 3 Jan 2005 17:19:53 -0700 (MST)
- Resent-from: tesla@xxxxxxxxxx
- Resent-message-id: <CTesmD.A.sGD.nEe2BB@poodle>
- Resent-sender: tesla-request@xxxxxxxxxx
Original poster: Ed Phillips <evp@xxxxxxxxxxx>
It's hard to explain without actually seeing it.
The wire is mounted on a free rolling spool near the floor. It rises
vertical to a piece of cardboard that is folded to form a V. The wire
runs
thru the cardboard V and changes direction by approx 70-80 degrees and
then
travels to the coilform held in the lathe or winder.
The cardboard folds around the wire. The small clamp allows you to vary
tension on the cardboard causing it to grip tight --- tension is
adjustable.
Hope this clears it up.
Dr. Resonance"
"The cardboard folds around the wire." Explains it all!
Ed