Re: New coiler questions

["Tesla list" <tesla-at-pupman-dot-com>]

Original poster: "Rodney Goolsby by way of Terry Fritz <teslalist-at-qwest-dot-net>" <jeronimo-at-bright-dot-net>


----- Original Message -----
From: "Tesla list" <tesla-at-pupman-dot-com>
To: <tesla-at-pupman-dot-com>
Sent: Sunday, May 04, 2003 5:52 PM
Subject: New coiler questions


 > Original poster: "by way of Terry Fritz <teslalist-at-qwest-dot-net>"
<Pomnept-at-aol-dot-com>
 >
 >         Does anybody know of a good means of raising the secondary coil up
and
 > down?  Would I use a brass screw or a plastic one?  The secondary would be
 > mounted on a plexiglass base.  I guess this is an engineering question.
 >         Also, can anybody recommend the site of a good NST protection
circuit
 > using readily available parts?  Your help is very much appreciated.
 >         Thanks,
 >         Robert


I prefer to order resistors and many other electronic parts
from www.digi-key-dot-com .  Just to be safe I recomend a plastic screw, but I
supose it depends where the srew is located, I just know my TC doesn't like
metal near the primary.