[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: Formless secondaries

To: tesla-at-pupman-dot-com
Subject: Re: Formless secondaries
From: "Tesla list" <tesla-at-pupman-dot-com>
Date: Thu, 13 Mar 2003 21:58:13 -0700
Resent-Date: Thu, 13 Mar 2003 23:34:39 -0700
Resent-From: tesla-at-pupman-dot-com
Resent-Message-ID: <A5z6CC.A.IsF.2fXc--at-poodle>
Resent-Sender: tesla-request-at-pupman-dot-com

Original poster: "by way of Terry Fritz <teslalist-at-qwest-dot-net>" <dhmccauley-at-spacecatlighting-dot-com>

See the pictures on the bottom of the following page.  They show how i
finished the top of my 10" secondary coil.

The Captain

http://www.spacecatlighting-dot-com/teslacoil7.htm



 > OK.
 >
 > Assuming I were to make an 8" to 10" formless
 > secondary, how would I support a rather large spun
 > aluminum topload?
 >
 > thanks
 > Adam

Prev by Date: Re: Inductance calculations
Next by Date: Re: New SSTC Design Topology
Prev by thread: RE: Formless secondaries
Next by thread: Re: Formless secondaries
Index(es):
- Date
- Thread