[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Phenolic Supplier question.

To: tesla-at-pupman-dot-com
Subject: Phenolic Supplier question.
From: "Tesla list" <tesla-at-pupman-dot-com>
Date: Wed, 08 May 2002 17:10:41 -0600
Resent-Date: Wed, 8 May 2002 17:12:47 -0600
Resent-From: tesla-at-pupman-dot-com
Resent-Message-ID: <Mcur6C.A.lrH.mDb28-at-poodle>
Resent-Sender: tesla-request-at-pupman-dot-com

Original poster: "Vince D'Amore by way of Terry Fritz <twftesla-at-qwest-dot-net>" <tesla-at-teslafx-dot-com>

Hello People,

  I'm currently trying to gather information and resources to build an SRSG.
I have noticed that most rotory disks are made of Phenolic LE or G10.
The research I have done so far shows that both of those materials
are pretty pricey. I have found them to run about 105.00 dollars per
sq. foot.
  Do any of you have a more economical solution or resource?
I will not risk safety so if I need to pay those prices I will. I'm just
checking to see if there is an alternative.


Vince

Prev by Date: Re: magnets in HDs
Next by Date: tuning a coil, guess and check?
Prev by thread: Re: Power Factor Cap
Next by thread: Re: Phenolic Supplier question.
Index(es):
- Date
- Thread