RE: 50Hz Vs. 60Hz supply

["sundog" <sundog-at-timeship-dot-net> (by way of Terry Fritz <twftesla-at-uswest-dot-net>)]

Hi all, Seth,

 Yep.  The rotary will go from a 60hz based breakrate to 50hz (1800 to 1500
rpm),
  The tranny will work fine, ballast (if it's there), diodes, etc.  The
pitch of the gap may be lower than you're accustomed to, but tha's about
all. :)
							Sundog

-----Original Message-----
From: Tesla list [mailto:tesla-at-pupman-dot-com]
Sent: Tuesday, October 10, 2000 9:47 AM
To: tesla-at-pupman-dot-com
Subject: 50Hz Vs. 60Hz supply


Original poster: "Seth Fischer" <aureo-at-xtra.co.nz>

Will a Tesla coil designed off 60Hz run just as well from a 50Hz supply?

Is it worth changing the design?

Seth Fischer