RE: 50Hz Vs. 60Hz supply

["harvey norris" <harvich-at-yahoo-dot-com> (by way of Terry Fritz <twftesla-at-uswest-dot-net>)]

--- Tesla list <tesla-at-pupman-dot-com> wrote:
> Original poster: "sundog" <sundog-at-timeship-dot-net> 
> 
> Hi all, Seth,
> 
>  Yep.  The rotary will go from a 60hz based
> breakrate to 50hz (1800 to 1500
> rpm),
>   The tranny will work fine, ballast (if it's
> there), diodes, etc.  The
> pitch of the gap may be lower than you're accustomed
> to, but tha's about
> all. :)

Wha!!!, the caps have to reconfigured to the new
frequency, there is almost a 20% difference of input
frequency here! So I disagree with that assesment. 
HDN					

		
> 
> -----Original Message-----
> From: Tesla list [mailto:tesla-at-pupman-dot-com]
> Sent: Tuesday, October 10, 2000 9:47 AM
> To: tesla-at-pupman-dot-com
> Subject: 50Hz Vs. 60Hz supply
> 
> 
> Original poster: "Seth Fischer" <aureo-at-xtra.co.nz>
> 
> Will a Tesla coil designed off 60Hz run just as well
> from a 50Hz supply?
> 
> Is it worth changing the design?
> 
> Seth Fischer
> 
> 
> 
> 
> 
> 


=====
Binary Resonant Systemhttp://www.insidetheweb-dot-com/mbs.cgi/mb124201