Re: HDPE SRSG DISK?

["Luc" <ludev-at-videotron.ca> (by way of Terry Fritz <twftesla-at-uswest-dot-net>)]

Hi

Is it possible to glue Lexan and the material of the print circuit  (G-10 ?)
together ? If it's possible you could sandwich it like 1/16" G-10 ,1/8" lexan ,
1/16" g-10, 1/8 lexan , 1/16 G-10. More easy to machine  than solid G-10
and more
resistant to heat than lexan .

Luc Benard

Tesla list wrote:

> Original poster: Terry Fritz <twftesla-at-uswest-dot-net>
>
> Hi Mike,
>
>         The stuff is too soft and melts at such a low temperature that the
> thing
> would just be a mess.  I made two gaps from HDPE.  One melted and the
other is
> just too unstable especially under the spinning stresses.  Lexan and, of
> course, the phenolics are a far better choice.
>
> Cheers,
>
>         Terry