[Prev][Next][Index][Thread]
Re: Electronic Work bench; better than priced bread
If Electronics Work Bench is so accurate than, why is it that I get over
2000 volts from stepping up 1 to 10, and then back down 10 to 1? I was only
using 6 volts AC.
This is the calculation that I was using to get the results. I calculated
XL of the primary of the 1 to 10 stage of the transformer to = 1 ohm at the
given frequency. F=1/2pi(L). Xc = 1 ohm at the same frequency, which is
placed in parallel with the primary. On the output side where the 1 to 10,
and the 10 to 1 were coupled together, Using Volt/Amperes = Output
Impedance, I placed the parallel value of inductive reactance in the
equation, to find the capacitor that had the equal value of reactance to
place in parallel with the two transformer coils.
After I started Getting some very chaotic readings, I found that the
optimum Q factor on the 10 side, a lower Q factor on the low, and with a
factor of 200, to 4000 working in the Meghertz range. If it wasn't for the
FCC I would build the thing. All I would need is some Power MOSFETs, and I
could build some small coil to practically beat the putz out of Over Unity
devices. I wouldn't say that Including the equations the cause the results.