[Home][2014 Index] Re: [TCML] Radial Spoke Primary [Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [TCML] Radial Spoke Primary


Or
Make all the spokes the same and offset each spoke by 1/4 of the spacing from the secondary, depending of course on how you are mounting the spokes. 

    Derek

On 05/07/2014 16:48, Jim Lux wrote:

If you have 4 spokes, offset the holes by 1/4 the spacing on each on.  For instance, if your turns are 1" apart, the first spoke has the holes at 1,2,3,4 inches,  the secon at 1.25,2.25,3.25,...
The third at 1.5, 2.5, 3.5,

Jim




Sent from Samsung tablet


-------- Original message --------
From: t-burns14 <t-burns14@xxxxxxxxxxx>
Date: 07/05/2014  04:55  (GMT-08:00)
To: tesla@xxxxxxxxxx
Subject: [TCML] Radial Spoke Primary

I'm about to drill holes in my HDPE spokes and realized that if I drill all the holes in line, I'll end up with concentric circles and then a bent piece to get to the next circle level. Not good. So how do I do this properly in order to get an actual spiral?
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla



--
Web:www.extremeelectronics.co.uk <http://www.extremeelectronics.co.uk>
Twitter @ExtElec <https://twitter.com/ExtElec>
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla