If you have 4 spokes, offset the holes by 1/4 the spacing on each on. For instance, if your turns are 1" apart, the first spoke has the holes at 1,2,3,4 inches, the secon at 1.25,2.25,3.25,...
The third at 1.5, 2.5, 3.5,
Jim
Sent from Samsung tablet
-------- Original message --------
From: t-burns14 <t-burns14@xxxxxxxxxxx>
Date: 07/05/2014 04:55 (GMT-08:00)
To: tesla@xxxxxxxxxx
Subject: [TCML] Radial Spoke Primary
I'm about to drill holes in my HDPE spokes and realized that if I drill all the holes in line, I'll end up with concentric circles and then a bent piece to get to the next circle level. Not good. So how do I do this properly in order to get an actual spiral?
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla