Re: [TCML] Black Plastic

[Joe Mastroianni <joe@xxxxxxxxxxxxxx>]

I take it back - it wasn't Delrin I had for a propeller gap, it was Ultem, which another coiler on this list used successfully.
But, anyway...
Joe

On Dec 9, 2011, at 5:57 AM, jhowson4@xxxxxxxxxxx wrote:

> Hello everyone, 
> 
> 
> I acquired a 1" OD length of black plastic from the machine shop here at college, I have no idea what it is. Its very hard, non translucent at its edges, not flexible. What is everyones opinion on it becoming a propeller gap spindle? 
> 
> 
> Thanks, 
> John "Jay" Howson IV 
> 
> _______________________________________________
> Tesla mailing list
> Tesla@xxxxxxxxxx
> http://www.pupman.com/mailman/listinfo/tesla

_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla