Re: [TCML] Primary Capacitors

[DC Cox <resonance@xxxxxxxxxxxx>]

I never said it was not possible ---- but certainly not a good engineering
approach when much better solutions are available.

yes, it can be done, however, the small leads and many connections present
significantly higher inductance (hence lower peak currents achieveable).

Our caps and Maxwell caps are widely used to overcome this problem.

Dr. Resonance




On Tue, Apr 13, 2010 at 2:58 PM, <mddeming@xxxxxxx> wrote:

>
> Hi Tom,
>
> It is POSSIBLE to make a multi-KVA pig-powered coil MMC. For what may be
> the largest MMC ever built, check out
>
> http://www.thegeekgroup.org/projects/high-voltage-projects/multiple-miniature-capacitor-array/array-assembly/
>
> I will not attest to the practicality of it (for other than brgging
> rights), just the possibility of doing it.
>
> Matt D
> In the interest of full disclosure:
> 1) I do not sell, broker, or have any financial interest in the sale of any
> type of Capacitors.
> 2) I am a member of the Geek Group.
>
>
>
>
> -----Original Message-----
> From: Thomas Schmit <Thomas.Schmit@xxxxxxx>
> To: Tesla Coil Mailing List <tesla@xxxxxxxxxx>
> Sent: Tue, Apr 13, 2010 12:55 pm
> Subject: RE: [TCML] Primary Capacitors
>
>
> Thanks! Glad to hear this now and not after ordering a bunch of little caps
> ;-)
> ooks like I'm back to shopping around.
>
> ut of curiosity, wouldn't the peak current of a string of caps be
> multiplied by
> he number of strings in parallel? So you could get to the 3500 amp by
> having
> oughly 8 strings in parallel? Of course, you still have all the connections
> to
> orry about.
>
> om
> ________________________________
> From: tesla-bounces@xxxxxxxxxx on behalf of DC Cox
> ent: Tue 4/13/2010 11:04 AM
> o: Tesla Coil Mailing List
> ubject: Re: [TCML] Primary Capacitance Calculations - "Black Boxes"
>
> Using MMCs with a pole xmfr will present problems.  Too many lead
> onnections lead to high relative inductance thus limiting peak currents in
> he discharge cycle.  Also, MMCs are not designed to handle the large peak
> urrents.
> Best to use a hi-Q factor energy discharge cap rated to do the job ----
> inimal internal connections that are accomplished with the extended foil
> esign connections.  Typical is a wide foil area with very low inductance
> onnections which permit high peak currents.
> A typical pole xmfr powered coil, operating with a .06 uF 80 kV energy
> ischarge capacitor will see peak currents of 3,500 Amps (or more) in the
> ischarge cycle.  Typically these pulses occur at around 400 pulses per
> econd for best coil performance which again would be a serious strain for
> n MMC which is rated at 432 Amps peak (max).
> Dr. Resonance
> _______________________________________________
> esla mailing list
> esla@xxxxxxxxxx
> ttp://www.pupman.com/mailman/listinfo/tesla
>
> _______________________________________________
> Tesla mailing list
> Tesla@xxxxxxxxxx
> http://www.pupman.com/mailman/listinfo/tesla
>
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla