RE: [TCML] JAVATC - Question

["Jim Mora" <wavetuner@xxxxxxxxx>]

-----Original Message-----
From: tesla-bounces@xxxxxxxxxx [mailto:tesla-bounces@xxxxxxxxxx] On Behalf
Of otmaskin5@xxxxxxx
Sent: Sunday, March 15, 2009 9:10 AM
To: tesla@xxxxxxxxxx
Subject: Re: [TCML] JAVATC - Question

Thanks Jim.? To clarify, I was planning to use a vacuum cleaner motor - the
air output side - for a blown style gap.? 

I had considered using brass dowels like you describe.? Can you give me a
little more info on how you mounted them, adjustability, connections, etc.?
I'm trying to see if this would be within my somewhat limited machining
capability.? Thx, Dennsi


-----Original Message-----
From: Jim Mora <wavetuner@xxxxxxxxx>
To: 'Tesla Coil Mailing List' <tesla@xxxxxxxxxx>
Sent: Sat, 14 Mar 2009 11:30 pm
Subject: RE: [TCML] JAVATC - Question



Hi,
It seems to me that hyperbaric, curved gaps have some complicated
aerodynamic physics....

<snip>

_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla