[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Re: [TCML] Secondary Troubles
Still here. I'm actually having baffles machined. They'll be press fit, no
glue required. I'm getting some nice brass pieces machined for the
secondary grounding/height adjustment.
On Sat, Jul 5, 2008 at 11:41 AM, <Sfxneon@xxxxxxx> wrote:
> In a message dated 7/4/2008 9:13:21 A.M. Central Daylight Time,
> pslawinski@xxxxxxxxx writes:
>
> << I set up my TC today to 'play'. I think I made a big mistake. I
> accidentally had the ungrounded low voltage lead from the secondary inside
> the coil form. To make a long story short my secondary PVC form now has
> some nice tree-like black tracks on the inside of it. The TC still works,
> and puts out streamers to about three and a half feet or more. >>
>
> It's a good idea to install baffles at each end of the secondary. Cut some
> plex discs to fit inside the PVC and epoxy or silicone them in place at
> each
> end of the tube. (Don't use a solvent type adhesive because it could leave
> explosive vapors inside the coil form!) This will almost insure that the
> arc
> can't take a short cut down the inside of the coil form, especially when
> your
> arcs start to get more than twice the secondary length. I actually
> installed
> three baffles inside my 8" coil just for good measure.
>
>
> << Should I stop coiling for making such a stupid mistake? >>
>
> The only stupid mistake is one that one that hurts YOU, and not a
> replaceable piece of pipe and a little bit of wire. Real learning comes
> from making
> your own "mistakes", and living to tell about them. Just look at how much
> you
> have already found out about how to prevent this from happening again. Not
> just
> from the replies from the list, but you now have first hand knowledge of
> what went wrong and why. Most of us have been there...done that...have the
> tons
> of fried parts to prove it, but keep on coiling anyway because with each
> failure comes a better, bigger coil the next time. And THAT'S what it's all
> about!
>
> Ya still with us, Phil?
>
> Tony Greer
>
>
>
>
> **************Gas prices getting you down? Search AOL Autos for
> fuel-efficient used cars. (
> http://autos.aol.com/used?ncid=aolaut00050000000007)
> _______________________________________________
> Tesla mailing list
> Tesla@xxxxxxxxxxxxxx
> http://www.pupman.com/mailman/listinfo/tesla
>
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla