Re: [TCML] winding secondary coils

[Slurp812 <slurp812@xxxxxxxxx>]

Check out my flicker electrical photo set. This was my first secondary, and
has yet to produce any sparks, but its getting closer. I rigged this stuff
up with much help from suggestions from people on this list, and many of
their websites...


http://www.flickr.com/photos/slurp812/sets/72157594444711276/



On Feb 4, 2008 10:04 PM, Clive Hansen <mrclivehansen@xxxxxxxxx> wrote:

> Hello Everyone,
>    I am about to begin winding a new secondary coil and need some tips
> on doing so. In the past, I have shoved a broom stick through the pipe,
> set it on two saw horses, and spun it by hand to wind it. However, this
> leaves a messy coil with lots of kinks. It is slow too. I have been
> thinking about using a lathe but can't seem to find one. Also, I don't
> have access to much space or many tools. Does anybody have good
> suggestions on how to wind this coil?
>
> Thanks,
> Clive Hansen
>
> --
> Clive Hansen
> http://clivetech.thruhere.net
>
> _______________________________________________
> Tesla mailing list
> Tesla@xxxxxxxxxxxxxx
> http://www.pupman.com/mailman/listinfo/tesla
>
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla