Re: [TCML] secondary scrape

[Yurtle Turtle <yurtle_t@xxxxxxxxx>]

Been there, done that. You will be fine. Just give it a couple of additional coats of poly.

Adam

--- On Fri, 8/1/08, John Matok <jmatoknoon@xxxxxxxxx> wrote:

> From: John Matok <jmatoknoon@xxxxxxxxx>
> Subject: [TCML] secondary scrape
> To: tesla@xxxxxxxxxx
> Date: Friday, August 1, 2008, 10:38 PM
> While filing my secondary to make it level, I accidentally
> scraped the file
> across about 2" of the wire.  I think  the form is
> okay, but I can see some
> bare wire where the enamel was scraped off.  What should I
> do?  I'm pretty
> concerned.
> John Matok
> _______________________________________________
> Tesla mailing list
> Tesla@xxxxxxxxxxxxxx
> http://www.pupman.com/mailman/listinfo/tesla


      
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla