Re: [TCML] MOT supply

["Peter Terren" <pterren@xxxxxxxxxxxx>]

The croc clips were not from the final setup but was a testing stage using 
an NST rather than the MOT.
"The center photo shows sparks of up to 1 inch from it from a 4 kV NST and a 
2 gap static gap."
I must have a bigger disclaimer in red  : )

Peter

----- Original Message ----- 
From: "David N. Van Doren" <DNVanDoren@xxxxxxxxxxx>
Sent: Wednesday, December 12, 2007 2:08 AM
Subject: Re: [TCML] MOT supply


> Hmmm - Pete, were those croc clip from the same MO  = D ...  I think we 
> have a cheater!!
> Good work Pete Keep up the Down Under Thunder
>
> ----- Original Message ----- 
> From: "Peter Terren" <pterren@xxxxxxxxxxxx>
> Sent: Tuesday, December 11, 2007 7:19 AM
> Subject: Re: [TCML] MOT supply
>
> > Of course a real man would only use a single microwave oven and nothing 
> > else to make a complete Tesla coil including tank cap, spark gap primary 
> > and secondary. Of course using the MO's normal timer as well.
> > http://tesladownunder.com/Solid%20State.htm#Tesla%20coil%20made%20from%20a%20microwave%20oven
> >
> > Peter
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla