[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: pvc pipe thickness.

To: tesla@xxxxxxxxxx
Subject: Re: pvc pipe thickness.
From: "Tesla list" <tesla@xxxxxxxxxx>
Date: Fri, 06 Oct 2006 19:57:29 -0600
Delivered-to: testla@xxxxxxxxxx
Delivered-to: tesla@xxxxxxxxxx
Old-return-path: <vardan01@xxxxxxxxxxxxxxxxxxxxxxx>
Resent-date: Fri, 6 Oct 2006 19:56:57 -0600 (MDT)
Resent-from: tesla@xxxxxxxxxx
Resent-message-id: <6Uz4tLM2-RJ.A.rVD.plwJFB@chip1>
Resent-sender: tesla-request@xxxxxxxxxx

Original poster: John <guipenguin@xxxxxxxxx>

Thanks.

Should the PVC pipe be coted with poly before AND on top of the coil?or just after?


On 10/5/06, Tesla list <<mailto:tesla@xxxxxxxxxx> tesla@xxxxxxxxxx> wrote:
Original poster: "Lau, Gary" <<mailto:Gary.Lau@xxxxxx> Gary.Lau@xxxxxx>

The only down side to what you have is that it will be heavier than a
thinner pipe.  But functionally speaking, this shouldn't matter.

Regards, Gary Lau
MA, USA


> Original poster: John < <mailto:guipenguin@xxxxxxxxx>guipenguin@xxxxxxxxx>
>
> I need a 4" diameter pvc pipe for my current coil spec.
>
> I got a cut off which has a thickness of about 1/4 an inch. Is this
too thick?
>

Prev by Date: Re: grounding question
Next by Date: RE: The Egg Works - Well, Almost
Previous by thread: RE: pvc pipe thickness.
Next by thread: RE: pvc pipe thickness.
Index(es):
- Date
- Thread