RE: PIRANHA-III Trigger Circuit (fwd)

["Tesla list" <tesla@xxxxxxxxxx>]

Moderated and approved by: Gerry Reynolds <greynolds@xxxxxxxxxx>



---------- Forwarded message ----------
Date: Sun, 24 Dec 2006 19:26:02 -0700
From: S&JY <youngsters@xxxxxxxxxxxxxxx>
To: 'Tesla list' <tesla@xxxxxxxxxx>
Subject: RE: PIRANHA-III Trigger Circuit (fwd)

No.
--Steve Young

-----Original Message-----
From: Tesla list [mailto:tesla@xxxxxxxxxx] 
Sent: Friday, December 22, 2006 3:37 PM
To: tesla@xxxxxxxxxx
Subject: Re: PIRANHA-III Trigger Circuit (fwd)

Original poster: Gerry Reynolds <greynolds@xxxxxxxxxx>



---------- Forwarded message ----------
Date: Fri, 22 Dec 2006 09:04:52 -0700
From: resonance <resonance@xxxxxxxxxxxx>
To: Tesla list <tesla@xxxxxxxxxx>
Subject: Re: PIRANHA-III Trigger Circuit (fwd)




Terry  or Steve  ---- do you have a Digi-Key parts list for this circuit?


Dr. Resonance


>>
>>Recently you mentioned you were going to try triggering your SIDAC-IGBT
>>stack with an ignition coil.  I came across an interesting and simple
>>variable rate trigger circuit for a strobe light which also uses a SIDAC!
>>It might work well for your trigger - see
>>http://geocities.com/lgtngstk/Strobe/Strobe.html.  Just substitute the
>>ignition coil for the trigger transformer.  Of course, eliminate the flash
>>tube & R1, and you will probably want to increase C3 to pump more energy
>>into the ignition coil and correspondingly decrease R3 and R2 to get the
>>break rate range you want.
>
> This is similar to the DF-DRSSTC pulse firing circuit I used on the
> DF-DRSSTC (upper right):
>
> http://hot-streamer.com/temp/DF-DRSSTC-SCHEMATIC.pdf
>
> Your circuit is pretty nice and easy and should work fine ;-))
>
>
>>Also, an ignition coil without a common
>>primary/secondary connection would be safer, or run the trigger from an
>>isolation transformer.
>
> I was going to use two ignition coils for total isolation since everything
> in the primary circuit is very hot!
>
> Cheers,
>
>         Terry
>
>
>
>>Merry Christmas,
>>--Steve Young
>
>
>
> 





-- 
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.




-- 
No virus found in this incoming message.
Checked by AVG Free Edition.
Version: 7.5.432 / Virus Database: 268.15.25/593 - Release Date: 12/19/2006
1:17 PM