RE: X-ray transformer (fwd)

["Tesla list" <tesla@xxxxxxxxxx>]

Original poster: Gerry Reynolds <greynolds@xxxxxxxxxx>



---------- Forwarded message ----------
Date: Fri, 15 Dec 2006 20:22:52 -0800
From: Jim Mora <jmora@xxxxxxxxxxx>
To: 'Tesla list' <tesla@xxxxxxxxxx>
Subject: RE: X-ray transformer (fwd)

Hello All,

Wanted Xray head Transformer to make a 50kv cap charger. Jim, is your
Transformer designed for that frequency or can you drive a typical head that
high? Sure cuts the size of capacitors for a doubler! I too am interested in
your SCR drawing.

Thanks,
Jim Mora

-----Original Message-----
From: Tesla list [mailto:tesla@xxxxxxxxxx] 
Sent: Friday, December 15, 2006 7:57 PM
To: tesla@xxxxxxxxxx
Subject: Re: X-ray transformer (fwd)

Original poster: Gerry Reynolds <greynolds@xxxxxxxxxx>



---------- Forwarded message ----------
Date: Fri, 15 Dec 2006 17:31:29 -0800 (PST)
From: Scott Kraus <plymouth_4406@xxxxxxxxx>
To: Tesla list <tesla@xxxxxxxxxx>
Subject: Re: X-ray transformer (fwd)

Jim,
   
   Do you have a diagram for the scr driver?  I believe I have most of the
parts all the way back to the pulse transformer board.
   
  Scott

Tesla list <tesla@xxxxxxxxxx> wrote:
  Original poster: Gerry Reynolds 



---------- Forwarded message ----------
Date: Thu, 14 Dec 2006 20:35:15 -0800
From: Jim Lux 
To: Tesla list , tesla@xxxxxxxxxx
Subject: Re: X-ray transformer (fwd)

At 05:08 PM 12/14/2006, Tesla list wrote:
>Original poster: Gerry Reynolds 
>
>
>
>---------- Forwarded message ----------
>Date: Thu, 14 Dec 2006 12:07:49 -0800 (PST)
>From: Scott Kraus 

>To: Tesla list 
>Subject: Re: X-ray transformer (fwd)
>
>Chip,
>
> I bought a unit similar to yours this summer. It was labeled as 
> a Picker high tension generator from a Picker Explorer 2 mobile 
> x-ray machine. It was powered by approximately 10 12 volt lead acid 
> batteries. I was not able to come up with a diagram for the driver 
> circuit but it came with a stack of large thyristors. According to 
> the data tag it requires 120 volts at 8 khz. I was able to get a 
> 9-10 inch spark by powering it with the lamp dimmer ignition coil 
> driver from a posting a couple of weeks ago. I substituted a 200 uf cap.



I have a GE xray system that runs at 500kHz (a pair of SCRs in a 
multivibrator configuration) running off a couple hundred volts of 
NiCd. Saves mucho mass on the transformer.






 __________________________________________________
Do You Yahoo!?
Tired of spam?  Yahoo! Mail has the best spam protection around 
http://mail.yahoo.com