[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
LM12CL Low-Z Amp
- To: tesla@xxxxxxxxxx
- Subject: LM12CL Low-Z Amp
- From: "Tesla list" <tesla@xxxxxxxxxx>
- Date: Thu, 29 Sep 2005 18:25:57 -0600
- Delivered-to: testla@pupman.com
- Delivered-to: tesla@pupman.com
- Old-return-path: <vardin@twfpowerelectronics.com>
- Resent-date: Thu, 29 Sep 2005 18:51:52 -0600 (MDT)
- Resent-from: tesla@xxxxxxxxxx
- Resent-message-id: <oonn2C.A.QvC.nwIPDB@poodle>
- Resent-sender: tesla-request@xxxxxxxxxx
Original poster: Phil Rembold <prembold@xxxxxxxxx>
Terry,
Just love your Amp, the spec's on the chip show it good up to 60 kHz
Quick question, hows it do at reproducing low freqs 1 to 20 Hz
--
Phil Rembold
TCBFW
Original poster: Terry Fritz
<<mailto:vardin@xxxxxxxxxxxxxxxxxxxxxxx>vardin@xxxxxxxxxxxxxxxxxxxxxxx>
Hi Jim,
snip
For the transmitter, any powerful signal source could drive it. I
would almost suggest an audio amplifier driven from a signal
generator. You could simply tune the frequency to resonate at the
best point. But, an audio amplifier might not go much above
20kHz. There are ICs that would work at higher frequencies such as
in my amplifier here:
<http://hot-streamer.com/TeslaCoils/Misc/Low-ZAmp/Low-ZAmp.jpg>http://hot-streamer.com/TeslaCoils/Misc/Low-ZAmp/Low-ZAmp.jpg
http://hot-streamer.com/TeslaCoils/Misc/Low-ZAmp/
Once setup, you could just tune the signal generator for the best
light output at the receiver. The biggest loss will be at the loose
coupling of the primary coils. The system really is just a
loosely-coupled air-core high voltage transmission line that works at
high frequency.
I don't think you are going to get a "return of 1000 times the input
energy." but it should be an interesting project.
Cheers,
Terry