[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
RE: Static gap construction
- To: tesla@xxxxxxxxxx
- Subject: RE: Static gap construction
- From: "Tesla list" <tesla@xxxxxxxxxx>
- Date: Thu, 06 Jan 2005 11:25:09 -0700
- Delivered-to: testla@pupman.com
- Delivered-to: tesla@pupman.com
- Old-return-path: <teslalist@twfpowerelectronics.com>
- Resent-date: Thu, 6 Jan 2005 11:59:42 -0700 (MST)
- Resent-from: tesla@xxxxxxxxxx
- Resent-message-id: <6WRCXD.A.9XB.eqY3BB@poodle>
- Resent-sender: tesla-request@xxxxxxxxxx
Original poster: "Mark W. Stolz" <mark_w_stolz@xxxxxxxxxxx>
Hi,
I've used Rob Judd's calculator at the following URL with good results.
http://homepage.a5.com/~canska/tesla/sparkgap.cgi
Mark Stolz
http://teslacoils4christ.org/
Pearland, TX
Original poster: "Black Moon" <black_moons@xxxxxxxxxxx>
Hi, im making a static gap out of 1/2" copper pipe sections mounted in a
PVC pipe with air blowing though it, and was wondering, how exactly do you
place the PVC pipe section drill holes with any accuracy? or calculate how
far they should be apart? or do you just drill slots and tune each section
before drilling the next?