[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
RE: PVC tube lacquer?
- To: tesla@xxxxxxxxxx
- Subject: RE: PVC tube lacquer?
- From: "Tesla list" <tesla@xxxxxxxxxx>
- Date: Sun, 17 Apr 2005 22:48:03 -0600
- Delivered-to: chip@pupman.com
- Delivered-to: tesla@pupman.com
- Old-return-path: <teslalist@twfpowerelectronics.com>
- Resent-date: Sun, 17 Apr 2005 22:48:51 -0600 (MDT)
- Resent-from: tesla@xxxxxxxxxx
- Resent-message-id: <SstjxB.A.PrC.vwzYCB@poodle>
- Resent-sender: tesla-request@xxxxxxxxxx
Original poster: "Ralph Zekelman" <gridleak@xxxxxxxxxxxxxx>
Willem,
It is not necessary to treat or bake the pvc. I would not use any
lacquer
or sealer having a suspension of metallic particles. I use polyurethane
varnish which is cheap and produces a nice finish. To avoid drips, it's
best to allow the form to rotate on the coil winder as each coat of PU
dries. Use 10-12 coats.
Ralph Zekelman
-----Original Message-----
From: Tesla list [mailto:tesla@xxxxxxxxxx]
Sent: Sunday, April 17, 2005 8:10 AM
To: tesla@xxxxxxxxxx
Subject: PVC tube lacquer?
Original poster: "Wim Bosma" <wbosma@xxxxxxxxxxx>
(Strange that this isolation repair spray, according to Internet
information, contains iron oxyde in its (red) mixture and is therefore
slightly ferro magnetic