[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]
Fiberglassing a 8 Inch PVC form
- To: tesla@xxxxxxxxxx
- Subject: Fiberglassing a 8 Inch PVC form
- From: "Tesla list" <tesla@xxxxxxxxxx>
- Date: Sat, 16 Apr 2005 11:07:56 -0600
- Delivered-to: chip@pupman.com
- Delivered-to: tesla@pupman.com
- Old-return-path: <teslalist@twfpowerelectronics.com>
- Resent-date: Sat, 16 Apr 2005 11:10:52 -0600 (MDT)
- Resent-from: tesla@xxxxxxxxxx
- Resent-message-id: <12DR9C.A.FSF.zaUYCB@poodle>
- Resent-sender: tesla-request@xxxxxxxxxx
Original poster: "Hydrogen18" <hydrogen18@xxxxxxxxxxxxx>
Hi, I have a piece of 8 inch ID, 9 inch OD white PVC I got for free. Its
kinda old, but was under dirt so it isnt actually deteroriated very bad at
all. Just needs to be cleaned up some and trimmed to length. Anyways, I
want to fiberglass it first, then wind, then fiberglass over the windings.
How does the resin react with PVC and the insulation on the magnet wire?
Has anyone tried this? T
Thanks,
Eric "Hydrogen18"