[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: NEW Self-Resonant COMPLETE SSTC Boards - BULK ORDER



Original poster: "Jim Mitchell" <electrontube-at-sbcglobal-dot-net> 

Sounds good,  But why don't you try to make the board more compact?  7X10 is
pretty big considering my SSTC boards were 2X3...  And the H bridge being on
there doesn't account for the large size,  I managed to fit an entire SSTC
into a
  5 X 6.75" base,  see here,
www.hot-streamer-dot-com/electrontube/temp/dsc01325.jpg and
www.hot-streamer-dot-com/electrontube/temp/dsc01324.jpg

It might seem that some people would want to make their own H bridge or
Halfbridge that way they could build the coil to their caterings.  45$ seems
like a lot,  considering those large SOT-227 IGBTs will cost about 20-30$
each depending on where you get them...

Good Luck.

Regards - Jim Mitchell

----- Original Message -----
From: "Tesla list" <tesla-at-pupman-dot-com>
To: <tesla-at-pupman-dot-com>
Sent: Saturday, April 10, 2004 2:39 PM
Subject: NEW Self-Resonant COMPLETE SSTC Boards - BULK ORDER


 > Original poster: "Eastern Voltage Research Corporation"
<dhmccauley-at-easternvoltageresearch-dot-com>
 >
 > My friends and I are making a bulk order board purchase for a  ISSTC /
SSTC
 > type Self-Resonant board.
 > The boards will be based on standard full-bridge technology and also be
 > self-resonant using a circuit tested and
 > perfected by Steve Ward, Justin Hayes, and others . . .  The boards will
 > also contain the standard TL494 based oscillator
 > if you wish to drive open loop.
 >
 > Full-Bridge portion of preliminary schematic
 > http://www.easternvoltageresearch-dot-com/sc2045_sheet1.pdf
 >
 > The boards will be approx. 10" x 7" in size, double-sided, silkscreened,
and
 > soldermasked just as the PlasmaSonic SSTC boards were.
 >
 > FEATURES:
 > Uses ISOPAK 227 type FETs or IGBTs (IXFN types or HGT IGBTs etc...) which
 > are
 > configued to mount underneath which can easily be attached to heat sink,
 > block of aluminum, etc...
 >
 > Power Full-Bridge will utilize copper planes, not traces, for improved
 > current handling and low inductance connections.
 >
 > Self-Resonant Circuit (either base-feed or antenna)
 >
 > Pulse Modulator system (for pulsing the output)
 >
 > Onboard Gate Drive system and Low Voltage Power Supply
 >
 > I will be selling these boards at cost for about $45.00 EACH.  The price
may
 > go lower if I get enough orders.
 >
 >