[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Topload question

To: tesla-at-pupman-dot-com
Subject: Topload question
From: "Tesla list" <tesla-at-pupman-dot-com>
Date: Fri, 24 Oct 2003 05:06:38 -0600
Resent-Date: Fri, 24 Oct 2003 05:11:20 -0600
Resent-From: tesla-at-pupman-dot-com
Resent-Message-ID: <nOnBS.A.2X.KjQm_-at-poodle>
Resent-Sender: tesla-request-at-pupman-dot-com

Original poster: "Robert Hanford" <pomnept-at-comcast-dot-net> 

My coil is a 6.34 diam. powered by 2  x<mailto:x15k-at-+or>15k-at-+or- 70ma NSTs. 
It's tapped at 7.5 turns of .25'' copper tubing.My topload is 6'' dryer 
duct, 18.5'' measured from the center of one side to the other. I have only 
cranked it up to about 80 volts, but I was getting about 3' maybe 3.5' 
streamers from a breakout point. I am using an SRSG.
I don't get -any- sparks without the breakout point (a sharp little tack.) 
The topload did not seem excessively big, judging by web sites. Any ideas?
Thanks in advance,
Robert Hanford

Prev by Date: Last reminder for North Texas teslathon
Next by Date: Re: Slighty zapped from metal casing
Prev by thread: Re: large toroids
Next by thread: First look at the "megafilter"...
Index(es):
- Date
- Thread