Re: Small coil questions?

["Tesla list" <tesla-at-pupman-dot-com>]

Original poster: "Kreso" <kreso.bukvic-at-kc.htnet.hr> 

The 3 mm is outer diameter so can i use it? What should be the space from
first primary turn to the secondary?

----- Original Message -----
From: "Tesla list" <tesla-at-pupman-dot-com>
To: <tesla-at-pupman-dot-com>
Sent: Monday, December 08, 2003 12:38 AM
Subject: Re: Small coil questions?


 > Original poster: "Jim Lux" <jimlux-at-earthlink-dot-net>
 >
 > Pretty much the same results from 3mm and 6mm tubing (is that inside
 > diameter or outside...)
 >
 > Best to make the relative heights of secondary and primary adjustable, so
 > that you can change it if you discover in testing that you are over or
under
 > coupled.  Some small plastic blocks or sections of plastic pipe might work
 > well
 >
 > ----- Original Message -----
 > From: "Tesla list" <tesla-at-pupman-dot-com>
 > To: <tesla-at-pupman-dot-com>
 > Sent: Sunday, December 07, 2003 10:11 AM
 > Subject: Re: Small coil questions?
 >
 >
 >  > Original poster: "Kreso" <kreso.bukvic-at-kc.htnet.hr>
 >  >
 >  > Can i use 3 mm copper tubing and obtain same results as with 6 mm?
 >  > Where should first turn of secondary be? With same level as beginning,
 >  > middle, end of first turn of primary?
 >  >
 >  > Thanks
 >  >
 >  >
 >
 >