Re: help limiting mots

["Tesla list" <tesla-at-pupman-dot-com>]

Original poster: "colin.heath4 by way of Terry Fritz <twftesla-at-qwest-dot-net>" <colin.heath4-at-ntlworld-dot-com>

yeah 4" across 1" thick and i think my perfomance is down due to my nst on
way out i arced it at end of wires and it has no power there like it used to
i opened the gap too wide and it is on its way out its fart as well so i
will try and rip of the resin when i have new one

----- Original Message -----
From: Tesla list <tesla-at-pupman-dot-com>
To: <tesla-at-pupman-dot-com>
Sent: Monday, January 21, 2002 9:36 PM
Subject: Re: help limiting mots


> Original poster: "by way of Terry Fritz <twftesla-at-qwest-dot-net>"
<A123X-at-aol-dot-com>
>
> That sounds pretty good. i'm surprised your not getting better spark
output.
> The only thing I can think is maybe you could do with a better primary.
When
> you say 4" spun toroid do you mean 4" across or 4" thick because a toroid
that
> is four inces thick might be too large for such a small coil.
>
> Mark
>
> In a message dated 1/21/02 1:19:07 PM Eastern Standard Time,
tesla-at-pupman-dot-com
> writes:
>
>
> >
> > my specs are 6kv 25ma nst 11turns primary tapped at 8 made from 18 swg
wire
> > ,secondary 2.2" by 12" 4" spun ali toroid, 4 gap staitic gap, .0132uf
mmc
> > cap
>
>
>
>
>
>
>