Re: PSpice modeling of spark gaps

To: tesla-at-pupman-dot-com
Subject: Re: PSpice modeling of spark gaps
From: Terry Fritz <terryf-at-verinet-dot-com>
Date: Sat, 07 Nov 1998 17:06:35 -0700
Approved: terryf-at-verinet-dot-com
In-Reply-To: <3643FA0D.6A7424BF-at-uswest-dot-net>
References: <3.0.6.32.19981106123800.00910100-at-verinet-dot-com>

I uploaded the model TC10-20.sch and graphic 10-20.gif that show the
continuous sync-gap model.  For a non-sync gap, just change the timing of
Vpulse from 8.3333uS to 8.4us to simulate a typical induction motor.

www.peakpeak-dot-com/~terryf/tesla/models/

	Terry


At 01:43 AM 11/7/98 -0600, you wrote:
>Gary,
>Terry has come up with a break which models the gap well. This was done by
>using an SBREAK which is pulsed (VPULSE). The parameters are editable. The
>SBREAK open and close voltage is set via the SBREAK, but the repetition rate,
>delay, etc..  is done via VPULSE variables. I would recommend downloading a
>schematic to take a look at the setup. You can download my schematic at
>http://www.geocities-dot-com/CapeCanaveral/Hangar/3108/simulation.htm . I have
>Terry's pulsed sbreak in my schematic. Terry may also have uploaded his
>pulsed sbreak on his page, but I'm not sure. The last time I was at Terry's
>page, he did have my schematic uploaded which does show his pulsed sbreak
>spark gap.
>Bart
>
>Tesla List wrote:
>
snip

References:

PSpice modeling of spark gaps

From: Gary Lau 06-Nov-1998 1003 <lau-at-hdecad.ENET.dec-dot-com> (by way of Terry Fritz <terryf-at-verinet-dot-com>)