Re: Tube coil frequency& oil resistance

• To: tesla-at-pupman-dot-com
• Subject: Re: Tube coil frequency& oil resistance
• From: "James" <elgersmad-at-email.msn-dot-com> (by way of Terry Fritz <terryf-at-verinet-dot-com>)
• Date: Thu, 05 Nov 1998 20:39:48 -0700
• Approved: terryf-at-verinet-dot-com

>Original Poster: "Grayson Dietrich" <greystone21-at-hotmail-dot-com>
>
, which brings me to my second
>question:
>Would being submersed in mineral oil adversely effect epoxy, plexiglass,
>or the magnet wire's coating?
>I know there are a huge variety of types of insulation for magnet wire;
>for those sages
>out there versed in such matters, would knowing that it was a dark,
>blackish red
>incolor help?
>Grayson Dietrich
>
>______________________________________________________
>Get Your Private, Free Email at http://www.hotmail-dot-com
>
>

    If you know that you will have to cut it to make it fit, test it in the
oven at 250* in the oven.  If you know your coil will be running hotter than
that then test it about where you think it would be.  Do you know the
boiling point of mineral oil?  You would have to know that.

• Prev: Re: Nitrogen laser power level and gas mixture
• Next: Re: NOT-Laser Triggered Spark Gap
• Index(es):
  • Main
  • Thread