[Prev][Next][Index][Thread]

resonance clarifications


The hook up was as follows:


SCOPE-probe---3
              3
              3  <-- Secondary
              3
              3
Signal gen ----

Note: Only one wire was connected to the generator output, even though there
are two output jacks on the generator.

The secondary has no top or bottom at this time.  It is just a solenoid with
no "top" capacitance.

How would I check for linearity?  Do you mean constant amplitude for a range
of frequencies?  

I don't know about the output voltage.  I assume that there is probably
very little current flowing.

The signal generator has a 75 Ohm label above the outputs.

Chip