[Home][2020 Index] Re: [TCML] JavaTC Help [Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [TCML] JavaTC Help



Thanks Matt! I didn't see the checkboxes at the top!

On Wed, Feb 12, 2020 at 2:57 PM derstrom8--- via Tesla <tesla@xxxxxxxxxx>
wrote:

> Hello Dan,
>
> Those entries are for a ribbon-style primary coil (a flat strip of copper
> or aluminum). See the below link for an example.
>
> http://www.teslacoildesign.com/images/primary02.jpg
>
>
> If your primary coil is using round tubing rather than a flat strip,
> simply leave them empty. Also make sure "Round" is selected instead of
> "Ribbon" at the top, under "Primary Wire Type".
>
> Best wishes,
> Matt Lewis, Fairlee VT
>
> -----Original Message-----
> From: Daniel Kunkel <dankunkel@xxxxxxxxx>
> To: Tesla list <tesla@xxxxxxxxxx>
> Sent: Wed, Feb 12, 2020 1:11 pm
> Subject: [TCML] JavaTC Help
>
> Hello,
> Can someone please explain the primary coil section for the following
> values?
>
>   - Ribbon Height
>   - Ribbon Thickness
>
> If I am using standard copper tubing, what values I put in here?
> Thanks,
> ~Dan
> Kansas City area (snowing again)
> _______________________________________________
> Tesla mailing list
> Tesla@xxxxxxxxxxxxxxxxxx
> https://www.pupman.com/mailman/listinfo/tesla
> _______________________________________________
> Tesla mailing list
> Tesla@xxxxxxxxxxxxxxxxxx
> https://www.pupman.com/mailman/listinfo/tesla
>
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxxxxxx
https://www.pupman.com/mailman/listinfo/tesla