To connect the NST secondary to the primary of the tank circuit, you can use very small wire because the current is so low. My pole pig powered coil only uses 22 gauge HV wire to connect to the primary tank circuit.
Steve
----- Original Message -----
From: "Matthew Deming" <mddeming44@xxxxxxxxx>
To: "Tesla Coil Mailing List" <tesla@xxxxxxxxxx>
Sent: Saturday, June 23, 2018 5:48:40 PM
Subject: Re: [TCML] MMC construction question
I used #10 stranded THHN run through 1/4" vinyl tubing as hookup wire and
1/4" polycarbonate sheet to mount caps. 10 years and still running.
On Sat, Jun 23, 2018, 6:36 PM James Janota <j.janota@xxxxxxxxxx> wrote:
> I have 24 942c6p15kf each with their own 0.5 watt 10Mohms resistor. I hope
> that’s enough. So the question becomes mounting them. How thick of
> plexiglass should suffice? What gauge wire should I use to connect the NST
> and the primary?
>
> Regards
>
> James Janota
> (727)512-7112 Phone
> (727)595-6625 Fax
>
> _______________________________________________
> Tesla mailing list
> Tesla@xxxxxxxxxxxxxxxxxx
> https://www.pupman.com/mailman/listinfo/tesla
>
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxxxxxx
https://www.pupman.com/mailman/listinfo/tesla
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxxxxxx
https://www.pupman.com/mailman/listinfo/tesla