I modified a 1725 rpm motor to run in salient pole operation years ago. It
will seek and then lock into phase and then break out again. I think I
recall reading that if you don't remove enough rotor material it will seek.
If you remove too much it will over heat.
So before to I take this back to machining, is it even worth it? What is
the best gap for NSTs? Is SRSG is the answer what is the preferred break
rate?
~Dan
To synch or not to synch
Kansas City area
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxxxxxxxxxx
https://www.pupman.com/mailman/listinfo/tesla