Miles,
I built a sync rotary one time using this exact model of motor. It easily handled
a 8 inch diameter disc made of G10, 3/8" thick, with two heavy copper
electrodes 3/8" diameter.
Cheers,
John
-----Original Message-----
From: Miles Mauldin <TeslaMiles@xxxxxxx>
To: Tesla Coil Mailing List <tesla@xxxxxxxxxx>
Sent: Fri, May 26, 2017 12:37 pm
Subject: Re: [TCML] Teletype motor for Sync 3600 RPM RSG for sale
Hi Gary!
I'm sure it was difficult to part with such an old friend. Question for you; how heavy is your contact disk for the RSG you'd use with this motor? And would the weight affect spin-up time or its ability to stay in sync?
Cheers!
Miles (the 'other' Miles)
Sent from a tiny device with a tiny keyboard via some cloud...
> On May 25, 2017, at 11:22 PM, Gary Lau <glau1024@xxxxxxxxx> wrote:
>
> Hi All,
>
> I just listed an extra Teletype synchronous motor I picked up at a flea
> market on eBay, just in case my RSG ever died. It didn't, so here's your
> chance to score a Teletype motor for your SRSG. It's extremely clean and
> comes fully wired with cap and relay and ready to plug in
>
> http://www.ebay.com/itm/-/172695462395?
>
> The motor ships from 02466 (eastern MA) with either local pickup or flat
> rate USPS shipping.
>
> Regards, Gary Lau
> MA, USA
> _______________________________________________
> Tesla mailing list
> Tesla@xxxxxxxxxx
> http://www.pupman.com/mailman/listinfo/tesla
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla