Hello Steve,
I have found that a minimum diameter of 3/8" pure tungsten can cope with just about anything you can throw at it. I have used them as flying electrodes as well as stationaries and wear is absolutely minimal.Pure 1/4" tungstens on the rotor of Phil Tuck's coil to which you alluded survived pretty well before their finning days pulling between 30 and 40A. Copper fins should hold up perfectly well at a least in our experience.
Have recently used 1/2" stationary and 3'8" flying electrodes in 40mm diameter copper rod columns with no finning and even prolonged runs at 40A on a large coil show virtually no wear. Did experiment with copper tungsten but ablation was severe.
Best of luck,Phillip.
_____________________________________________________________________________
14 Broad Street, Stamford, Lincs PE9 1PG
Tel: 01780 753008
From: Steve White <steve.white1@xxxxxxxxx>
To: Tesla Coil List <tesla@xxxxxxxxxx>
Sent: Thursday, 17 August 2017, 13:09
Subject: [TCML] Electrode erosion
In an attempt to reduce the erosion of my stationary RSG tungsten electrodes, I machined on my lathe a set of small heat sinks that mount 1/2" away from the spark gap firing point. They are similar to those shown on the "hvtesla.com" web site except mine are made from aluminum instead of copper. The problem is that the high temperature seems to be pitting the face of the heat sinks facing the spark gap. I note that aluminum melts at 1200 degrees F and copper melts at 1900 degrees F.
In an attempt to correct this pitting problem I have ordered a set of aluminum nitride sheets. Each is 1.5" x 1.5" x 1 mm. Aluminum nitride is a ceramic which melts at 4000 degrees F. My idea is to attach these small sheets to the face of the heat sink closest to the spark gap in order to prevent the pitting (melting) of the aluminum. I then wondered if attaching copper sheets to the aluminum would have done the job since copper's melting point is higher.
Does anyone using copper heat sinks on the stationary tungsten electrodes have a problem with the copper pitting (melting)?
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla