On 12/24/15 5:56 AM, ExtremeElectronics.co.uk wrote:
Stefan.
Initially I decided to go with the traditional build. Id had my
fill of electronics and wanted something different (I then built a uP
speed control for the motor)
So, hair dryer v High voltage supply.
I've thought about it, but I'd need to change my bottom roller to
Aluminum. I don't have the workshop tools to make another crowned
roller. The last two rollers were machined for me, so it will have to
wait until someone with a lathe owes me a favour..
You can wrap tape around the roller to make a crown. All it needs to be is a bit bigger in the middle than on the sides.
_______________________________________________ Tesla mailing list Tesla@xxxxxxxxxx http://www.pupman.com/mailman/listinfo/tesla