Here is a better diagram of the MMC http://postimg.org/image/vptl7mjox/
My only question is concerning the position of the spark gap. In most
diagrams of Tesla coils, both outputs of the transformer connect without
any interruption but the cap MMC and the primary coil. The spark gap only
seems to be fired when the circuit cannot hold any more energy. This just
looks a little problematic to me as both ends of the transformer are
connected without the spark gap blocking the connection, but just waiting
for a surge of energy to shoot across the gap. From looking at other
diagrams online, the drawing in the first email should be correct, but I am
just not 100% sure.
On Thu, Mar 27, 2014 at 5:32 PM, Gary Lau <glau1024@xxxxxxxxx> wrote:
> Hi Kuba,
>
> I couldn't quite understand the wiring of the MMC caps and bleeder
> resistors. It looks like you have a 10 Ohm resistor is series with each
> cap. It should be a 10MegOhm resistor in parallel with each cap. I assume
> this is just a typo/graphical error?
>
> Regards, Gary Lau
> MA, USA
>
>
> On Wed, Mar 26, 2014 at 8:44 PM, Kuba Anglin <kubaanglin@xxxxxxxxx> wrote:
>
> > I am about to wire up my Tesla coil and just wanted to check if I have it
> > right before I start attaching wires. Here is my sketch:
> > http://postimg.org/image/kchnxc2cz/
> > _______________________________________________
> > Tesla mailing list
> > Tesla@xxxxxxxxxx
> > http://www.pupman.com/mailman/listinfo/tesla
> >
> _______________________________________________
> Tesla mailing list
> Tesla@xxxxxxxxxx
> http://www.pupman.com/mailman/listinfo/tesla
>
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla