[Home][2014 Index] Re: [TCML] fluid quenched rotary spark gap [Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [TCML] fluid quenched rotary spark gap



Is sodium hex what is used in medium voltage (up to 25 kV) breaker 'bottles"? If so, a static gap minght be a better approach in this. We used breakers at work up to 25 kV as breakers and switches, as it quenches arcing to protect the electrodes. The bottles can be purchased ready made, so no need for fabrication. They rarely see several operations per day, so I don't know how they'd perform at 120 bps.




________________________________
 From: Phil Tuck <pip@xxxxxxxxxxx>
To: 'Tesla Coil Mailing List' <tesla@xxxxxxxxxx> 
Sent: Wednesday, April 9, 2014 3:41 AM
Subject: Re: [TCML] fluid quenched rotary spark gap
 

Never tried, but I would imagine the drag from the fluid would be excessive
and the motor size needed would make things impracticable. When modifying to
synchronous, the motor looses quite a lot of power in the conversion. I can
see the motor burning out if you're not careful. 
A better approach would be a gas filled box. Sulphur hexafluoride is an
excellent insulator and is heavier than air so if it leaks you know where
it's gone.
Also steel and RF do not work together, and you will still get excessive
heating, which in itself won't help quenching.
The extra expense of either of the above mentioned gaps, would surely be
more than sourcing the Tungsten rod needed for an ordinary gap?
I would estimate, from doing runs using just a dummy secondary load, that
only 2/3 of the noise comes from the gap on a big coil. The lower the power
of the coil, the more noise just comes from the gap, and less from the
streamers.


Phil

www.hvtesla.com


-----Original Message-----
From: tesla-bounces@xxxxxxxxxx [mailto:tesla-bounces@xxxxxxxxxx] On Behalf
Of David Boyle
Sent: 09 April 2014 02:32
To: tesla@xxxxxxxxxx
Subject: [TCML] fluid quenched rotary spark gap

I'm planning to build a synchronous rotary spark gap with the terminals
inside a fluid tight plastic box and filled with dielectric oil. This should
cut down on the noise, allow me to use steel electrodes because of the lower
temperatures, and it should quench like a champ. Has anyone had any
experience building one of these?
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla


_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla