Re: [TCML] DIY dent-proof Toroids

[Clive Penfold <clivepenfold@xxxxxxxxxxxxxx>]

I'm sure it has been mentioned before, but why not use a vehicle inner tube as a mould. The only disadvantage that I can see is after you have cut off the tube, you would need to glue in a centre disc which wouldn't be as strong as in Phil's design
.
In the UK, the cheapest source of aerosol expanding foam that I have found is Toolstation


http://www.toolstation.com/shop/Adhesives%20&%20Sealants/Expanding%20Foam/Expanding%20Foam/d180/sd2857/p27912

Clive




>________________________________
> From: "mddeming@xxxxxxx" <mddeming@xxxxxxx>
>To: tesla@xxxxxxxxxx 
>Sent: Monday, 27 May 2013, 17:34
>Subject: Re: [TCML] DIY dent-proof Toroids
> 
>
>Perhaps "spin-balancing" while it cured would solve some of the distribution problem, especially if done in several steps, building towards the inside to allow proper out-gassing. When in a confined space with some air, the out-gassed fumes from "Great-Stuff" foam are nicely explosive!
>
>
>Matt D.
>
>
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla