Thanks Phil.
I double checked, and everything was input OK. However, I decreased the
secondary number of turns and one gauge smaller wire and the toroid in the
drawing is where it belongs.(?) The spark length under Power calculated at
107", which I thought wasn't bad using a PT.
Any other thoughts will be appreciated.
Thank you,
Tim
On Tue, Jul 23, 2013 at 9:40 AM, Phil Tuck <phil@xxxxxxxxxxx> wrote:
Tim,
In the section titled "Top Load Objects", check your "Toroid Centre Height"
entry, in the first, of the four differant differant types of toroid
choices.
Also make sure you've not mixed units (inches & centimrtres)
Phil
-----Original Message-----
From: tesla-bounces@xxxxxxxxxx [mailto:tesla-bounces@xxxxxxxxxx] On Behalf
Of Tim Flood
Sent: Monday, July 22, 2013 9:58 PM
To: tesla@xxxxxxxxxx
Subject: [TCML] JAVATC
When running the numbers and finally ending up with a very good RSG Spark
length, the small drawing Under the Primary Output Data shows the toroid
located about a third of the way down from the top of the secondary.
Why? I'm probably missing something obvious.
Thanks for any advice.
Tim Flood
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla