Re: [TCML] The Practical construction of VTTCs

[Neon Tesla <neontesla@xxxxxxxxx>]

Thanks that helps because the other sheet labeled pin 2
as "NC"

On Fri, Jul 20, 2012 at 1:33 PM, Yurtle Turtle <yurtle_t@xxxxxxxxx> wrote:

> Or just click here:
>
> http://lmgtfy.com/?q=811+tube+pinout
>
>
>
> ________________________________
>  From: "mddeming@xxxxxxx" <mddeming@xxxxxxx>
> To: tesla@xxxxxxxxxx
> Sent: Friday, July 20, 2012 2:13 PM
> Subject: Re: [TCML] The Practical construction of VTTCs
>
>
>
> Get the datasheet that was recommended six days ago and the RCA manual.
>
> All is explained therein.
>
>
> MDD
> PS: Tubes have grids, not gates.
>
> -----Original Message-----
> From: Neon Tesla <neontesla@xxxxxxxxx>
> To: Tesla Coil Mailing List <tesla@xxxxxxxxxx>
> Sent: Thu, Jul 19, 2012 10:08 pm
> Subject: Re: [TCML] The Practical construction of VTTCs
>
>
>        Big question how do I identify the pins for the Cathode Gate
> and filament input? (sorry I'm new to this)
>
>
>
>
>
> _______________________________________________
> Tesla mailing list
> Tesla@xxxxxxxxxx
> http://www.pupman.com/mailman/listinfo/tesla
> _______________________________________________
> Tesla mailing list
> Tesla@xxxxxxxxxx
> http://www.pupman.com/mailman/listinfo/tesla
>



-- 
*Don't lower your expectations, raise the voltage !*
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla