Re: [TCML] High voltage Scope Probe Request

[Eric Goodchild <ericgoodchild@xxxxxxxxx>]

On 7/4/2011 1:22 PM, Hawkspirit wrote:
> Can anyone recommend a high voltage scope probe model that I can use to
> connect directly on to the primary tank circuit in operation using my
> oscilloscope?
>
> Roger
>
>
> _______________________________________________
> Tesla mailing list
> Tesla@xxxxxxxxxx
> http://www.pupman.com/mailman/listinfo/tesla
You know you only need a HV probe to measure between the C and L node on 
the primary.  This is assuming you are using a DR. If this is the case 
the you can test on ether of the outputs of the bridge.

In the case of a SGTC you would need a HV probe. I have seen many on 
ebay for modest price. If you do buy one get a capacitive divider type 
probe.

You may also find this interesting as well. On 4hv I have been following 
a thread about building a DIY based HV probe for oscilloscope. It seems 
like it may work for what you are doing. 
http://4hv.org/e107_plugins/forum/forum_viewtopic.php?118895


Good Luck,
Eric
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla