RE: [TCML] Sync gap setup

["Phil Tuck" <phil@xxxxxxxxxxx>]

Brad
What bps are you running? If the four rotating pass through the disc and the
two stationary are one either side ( 1 in front & the other behind) at say 3
o'clock then on a 1800 rpm you will have 120bps. This will suffer from
resonant rise much more than say 240bps, so your timing will need to be spot
on @ 120bps and you will definitely need John's phase controller.

Regards
Phil

www.hvtesla.com


-----Original Message-----
From: tesla-bounces@xxxxxxxxxx [mailto:tesla-bounces@xxxxxxxxxx] On Behalf
Of B McPeak
Sent: 10 January 2011 06:42
To: tesla@xxxxxxxxxx
Subject: [TCML] Sync gap setup

Hello,
	I need some help setting up a synchronous rotary gap. I have built
several coils with static gaps. This is the first sync one. Gap is 1800 RPM
motor and four tungsten flying  electrodes, and 2 stationary. Phase is
adjusted by disc position. Have built a larger MMC bank for rotary operation
per a design program. Any help on getting the phase adjusted with simple
tools would be greatly appreciated.
Thanks.

Brad McPeak

_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla

_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla