PBT,
Nice job.
Looks similar to mine. Those HV sparks look stange and a little dangerous.
Personally, I would not run the HV leads up inside of the lateral PVC
support pipes. I ran mine to the upper and lower bearing housings. I ran
the the upper wire down the inside of the horizontal pipe from a hole
drilled in the elbow. I believe you'll get more thrust and speed.
I never used regulated HVDC currrent, but always HVAC. You may want to
power it with a NST. Use a cap and maybe a couple of MWO diodes. I suspect
you'll obtain even more performance. BTW, did you detect any ions or wind
exiting the ends of the thrusters?
Stork
----- Original Message -----
From: mrapol@xxxxxxxxxxxx
To: "Tesla Coil Mailing List" <tesla@xxxxxxxxxx>
Sent: Friday, February 11, 2011 12:57:52 PM
Subject: Re: [TCML] Thruster success
Video of the thrusters at:
http://www.youtube.com/watch?v=LrF_8O8kPCU
PBT
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla
_______________________________________________
Tesla mailing list
Tesla@xxxxxxxxxx
http://www.pupman.com/mailman/listinfo/tesla